Здравствуйте!
не посылайте гуглить - уже загуглился. мануалы читал, примеры смотрел,
решение проблемы как на этом форуме, так и на других искал. не помогло.
получаю внутренний айпишник 10.93.91.34, шлюз 10.93.91.1, сервер
подлючений 10.90.1.3. После подключения должен получиться айпишник
89.106.39.199
ниже - конфиги и лог
mpd.conf
default:
load promira
promira:
new -i ng0 promira promira
set iface idle 0
set iface route default
set bundle disable multilink
set bundle authname "login"
set bundle password "password"
set ipcp ranges 0.0.0.0/0 0.0.0.0/0
set link keep-alive 60 180
set link accept chap
set link no pap
set bundle disable compression
set ccp yes mpp-e40
set ccp no mpp-e128
set bundle disable crypt-reqd
set ccp no mpp-stateless
set ipcp no vjcomp
set link mtu 1460
open
mpd.links
promira:
set link type pptp
set pptp peer 10.90.1.3
#set pptp self
set pptp enable originate incoming outcall
лог
[root@lepis ~]# mpd
Multi-link PPP for FreeBSD, by Archie L. Cobbs.
Based on iij-ppp, by Toshiharu OHNO.
mpd: pid 2490, version 3.18 (root@l*****.ru 19:23 1-Apr-2007)
[promira] ppp node is "mpd2490-promira"
mpd: local IP address for PPTP is 0.0.0.0
[promira] using interface ng0
[promira] IPCP: peer address cannot be zero
[promira] IFACE: Open event
[promira] IPCP: Open event
[promira] IPCP: state change Initial --> Starting
[promira] IPCP: LayerStart
mpd: warning: line too long, truncated
[promira:promira] [promira] bundle: OPEN event in state CLOSED
[promira] opening link "promira"...
[promira] link: OPEN event
[promira] LCP: Open event
[promira] LCP: state change Initial --> Starting
[promira] LCP: LayerStart
[promira] device: OPEN event in state DOWN
pptp0: connecting to 10.90.1.3:1723
[promira] device is now in state OPENING
pptp0: connected to 10.90.1.3:1723
pptp0: attached to connection with 10.90.1.3:1723
pptp0-0: outgoing call connected at 64000 bps
[promira] PPTP call successful
[promira] device: UP event in state OPENING
[promira] device is now in state UP
[promira] link: UP event
[promira] link: origination is local
[promira] LCP: Up event
[promira] LCP: state change Starting --> Req-Sent
[promira] LCP: phase shift DEAD --> ESTABLISH
[promira] LCP: SendConfigReq #1
ACFCOMP
PROTOCOMP
MRU 1500
MAGICNUM 2523f37a
[promira] LCP: rec'd Configure Request #1 link 0 (Req-Sent)
AUTHPROTO CHAP MSOFTv2
MAGICNUM 1c8545b5
[promira] LCP: SendConfigAck #1
AUTHPROTO CHAP MSOFTv2
MAGICNUM 1c8545b5
[promira] LCP: state change Req-Sent --> Ack-Sent
[promira] LCP: rec'd Configure Ack #1 link 0 (Ack-Sent)
ACFCOMP
PROTOCOMP
MRU 1500
MAGICNUM 2523f37a
[promira] LCP: state change Ack-Sent --> Opened
[promira] LCP: phase shift ESTABLISH --> AUTHENTICATE
[promira] LCP: auth: peer wants CHAP, I want nothing
[promira] LCP: LayerUp
[promira] CHAP: rec'd CHALLENGE #1
Name: "pmn-gw-g2"
Using authname "bukreev"
[promira] CHAP: sending RESPONSE
[promira] CHAP: rec'd SUCCESS #1
MESG: S=9A0662F3B8C39FA5D4008B58EC78B63DE6BC861D
[promira] LCP: authorization successful
[promira] LCP: phase shift AUTHENTICATE --> NETWORK
[promira] setting interface ng0 MTU to 1460 bytes
[promira] up: 1 link, total bandwidth 64000 bps
[promira] IPCP: Up event
[promira] IPCP: state change Starting --> Req-Sent
[promira] IPCP: SendConfigReq #1
IPADDR 0.0.0.0
[promira] error writing len 14 frame to bypass: Network is down
[promira] IPCP: rec'd Configure Request #1 link 0 (Req-Sent)
IPADDR 0.0.0.0
no IP address available for peer!
NAKing with 0.0.0.0
[promira] IPCP: SendConfigNak #1
IPADDR 0.0.0.0
[promira] IPCP: rec'd Configure Request #2 link 0 (Req-Sent)
[promira] IPCP: SendConfigAck #2
[promira] IPCP: state change Req-Sent --> Ack-Sent
[promira] IPCP: SendConfigReq #2
IPADDR 0.0.0.0
[promira] IPCP: rec'd Configure Nak #2 link 0 (Ack-Sent)
IPADDR 89.106.39.199
89.106.39.199 is OK
[promira] IPCP: SendConfigReq #3
IPADDR 89.106.39.199
[promira] IPCP: rec'd Configure Ack #3 link 0 (Ack-Sent)
IPADDR 89.106.39.199
[promira] IPCP: state change Ack-Sent --> Opened
[promira] IPCP: LayerUp
89.106.39.199 -> 0.0.0.0
[promira] IFACE: Up event
[promira] setting interface ng0 MTU to 1460 bytes
[promira] exec: /sbin/ifconfig ng0 89.106.39.199 0.0.0.0 netmask
0xffffffff -link0
[promira] exec: command returned 256
[promira] exec: /sbin/route add 89.106.39.199 -iface lo0
[promira] exec: /sbin/route add 0.0.0.0 0.0.0.0
[promira] exec: command returned 256
[promira] IFACE: Up event
[promira:promira]
когда подключен, делаю netstat -nr, вот что выдает:
[root@lepis ~]# netstat -nr
Routing tables
Internet:
Destination Gateway Flags Refs Use Netif Expire
default 10.93.91.1 UGS 0 1840 rl0
10.93.91/24 link#2 UC 0 0 rl0
10.93.91.1 00:0f:e2:3f:3d:7f UHLW 2 0 rl0 1180
89.106.39.199 lo0 UHS 0 0 lo0
127.0.0.1 127.0.0.1 UH 0 0 lo0
172.30 link#1 UC 0 0 ural0
172.30.0.10 00:17:9a:81:30:e5 UHLW 1 3930 ural0 889
а вот что показывает ифконфиг
[root@lepis ~]# ifconfig ng0
ng0: flags=8890<POINTOPOINT,NOARP,SIMPLEX,MULTICAST> mtu 1460
вроде подключается, но в инет не достучаться.
мужики, выручайте, уже 2 ночи не спал нормально /если не сложно -
разжуйте и с примерами, а то торможу уже. на работе туплю, все из рук
валится...
заранее спасибо всем откликнувшимся
-*Название листа "Linux: разрешение вопросов, перспективы и общение";
Написать в лист: mailto:comp.soft.linux.discuss-list@subscribe.ru
Адрес правил листа http://subscribe.ru/catalog/comp.soft.linux.discuss/rules
Номер письма: 31025; Возраст листа: 1350; Участников: 1450
Адрес сайта рассылки: http://www.linuxrsp.ru
Адрес этого письма в архиве: http://subscribe.ru/archive/comp.soft.linux.discuss/msg/653857
